![]() ![]() I heated it until it appeared that all the solder balls had become shiny, and flattened down slightly.Īfter a few minutes, it was soldered on. I then positioned the hot air nozzle over the top of the socket, and set it at around 250 degrees C (right below the melting point (I think) of the high-temp plastic used on these sockets), and began heating it. So, I turned my board preheater on to a very high temperature (220 degrees C), to provide most of the heating needed to melt the solder to the bottom of the board. Now, when soldering the socket on, I had to do it in such a way that the plastic of the socket wouldn't melt. macOS Catalina (10.15) Si vous utilisez macOS Mojave sur votre Mac, il y a de fortes chances que vous puissiez installer macOS Catalina. Once I got it in what I think was an aligned position, I began the soldering process. Since the markings around the CPU pads are not designed to guide you in soldering on a socket, I simply had to do some eyeballing and careful nudging around with a pair of tweezers. The most difficult part about doing this was properly aligning the socket onto the board. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. Archives
March 2023
Categories |